Material Information
Press In & Snap In
Standard materials:
Polyurethane - HNBR - NBR - EPDM - FKM - TFE/P
Manufacturing process:
- Machining (Seal24)
- Molding
Low Friction
Standard materials:
PTFE Unfilled - PTFE Bronzed Fill - PTFE with other fillers
Manufacturing process:
- Machining (Seal24)
Scrapers
Standard materials:
Acetal (POM), Nylon, Peek
Manufacturing process:
- Machining (Seal24)
SNAP IN
Lip designed to remove lightly adhered dirt from the rod i.e. mud, dust or moisture.
The wiper is manufactured from a polyurethane or nitrile rubber suitable for installing in a grooved housing.
Stepped design improves housing static seal.
Wiping lip design ensure that contact is maintained with the surface of the rod to remove all deposits of mud and other forms of contamination except for those found in heavy industrial applications.
Design provides interference fit with the housing for a better static seal on the OD. Recessed beveled wiping lip provides better protection from debris.
Double-lipped, snap-in wiper
Designed to have an interference in the seal housing groove to improve the stability of the wiper in the gland and to reduce the possibility of ingress around the outside of the wiper.
The sealing lip helps prevent oil transfer out of the ram on the cylinder rod by collecting traces of fluid passing the rod seal.
Stepped design improves housing static seal.
Same as W121
Wiper is developed specifically for use in harsher environments with heavy contamination, such as in agriculture, off-highway, forestry, and long wall mining equipment.
Wiper design used in conjunction with hat packing in older cylinder designs.
PRESS IN
Lip designed to remove lightly adhered dirt from the rod i.e. mud, dust or moisture.
The wiper is manufactured from a polyurethane or nitrile rubber suitable for installing in a grooved housing.
Design provides interference fit with the housing for a better static seal on the OD. Recessed beveled wiping lip provides better protection from debris.
Double-lipped, snap-in wiper
Designed to have an interference in the seal housing groove to improve the stability of the wiper in the gland and to reduce the possibility of ingress around the outside of the wiper.
The sealing lip helps prevent oil transfer out of the ram on the cylinder rod by collecting traces of fluid passing the rod seal.
LOW FRICTION
- O-Ring energizer to keep the wiper centered
- Capable of high-speed applications
- Eliminates any potential for stick-slip.
Rod wiper/excluder uses a single aggressive wiping lip that provides ingression protection.
- Double-acting
- O-Ring energized
The two lips combine to scrape debris from the rod and contain residual oil on rod extension, as well as allowing oil to pump back into the cylinder.
- Double-acting
- Two O-Ring energized
- Heavy-duty applications
The two lips combine to scrape debris from the rod and contain residual oil on rod extension, as well as allowing oil to pump back into the cylinder.
- Small Diameters
- Low-Friction
Relieve groove design provides a low-friction wiping lip for small diameters for hydraulic or pneumatic applications.
SCRAPERS
- Heavy-duty wiper to scrape off built-up debris.
- Made from high performance plastic material
- Scrape off built-up debris, including ice.
- Made from high performance plastic material
- Fits in applications with limited space.